User Manual

BOOMERANG EP Instruction Manual.
2
ank you for choosing the BOOMERANG EP ARTF by SEAGULL MODELS COMPANY
LTD,. e was designed with the intermediate/advanced sport yer in mind. It is a semi scale
airplane which is easy to y and quick to assemble. e airframe is onventionally built using bal-
sa, plywood to make it stronger than the average ARTF, yet the design allows the aeroplane to be
kept light. You will nd that most of the work has been done for you already. e motor mount
has been tted and the hinges are pre-installed. Flying the BOOMERANG EP is simply a joy.
is instruction manual is designed to help you build a great ying earoplane. Please read
this manual throughly before starting assembly of your BOOMERANG EP. User the parts
listing below to indentify all parts.
Please be awere that this aeroplane is not a toy and if assembley or used incorrectly it is
capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU
ASSUME ALL RISK & REPONSIBILITY.
If you are inexperianced with basic R/C ight we strongly recommend you contact your R/C
supplier and join your local R/C model Flying Club. R/C Model Flying Clubs oer a variety
of training procedures designed to help the new pilot on his way to successful R/C ight.
ey will also be able to advise on any insurance and safety regulations that may apply.
INTRODUCTION.
WARNING.
ADDITIONAL ITEMS REQUIRED.
TOOLS AND SUPPLIES.
• .40-.46 2-stroke engine.
• 4 channels radio with four servos.
• Glow plug to suit engine.
• Propeller to suit engine.
• Protective foam rubber for radio system.
• Silicone fuel line.
• Stick-on weights for balance
• ick cyanoacrylate glue.
• 30 minute epoxy.
• 5 minute epoxy.
• Hand or electric drill.
• Assorted drill bits.
• Modelling knife.
• Straight edge ruler.
• 2mm ball driver.
• Phillips head screwdriver.
• 220 grit sandpaper.
• 90° square or builder’s triangle.
• Wire cutters.
• Masking tape & T-pins.
• read-lock.
• Paper towels.
KIT CONTAIN.
FUSELAGE ASSEMBLY
- (1) Fuselage.
- (1) Pre-installed throttle pushrod & tube.
- (1) Pre-installed servo tray.
- (1) Pre-installed motor mount.
- (1) Pre-installed rudder pushrod.
- (1) Pre-installed elevator pushrod.
WING ASSEMBLY
- (1) Right wing half with preinstalled aileron.
- (1) Le wing half with pre-installed aileron.
- (1) Aluminium wing tube.
- (1) Covering strip for centresection joint.
TAIL SECTION ASSEMBLY
- (1) Vertical stabilizer with preinstalled rudder.
- (1) Horizontal stabilizer with preinstalled el-
evator halves