User Manual

WWW.SEAGULLMODELS.COM
27
.
INSTALLATION PILOT AND CANOPY.
1) Locate items necessary to install pilot,
seats.
2) A scale pilot is included with this ARF.
e Seagull Pilot included tting well to
the cockpit. (or you can order others scale
pilot gures made by Seagull factory.
ey are available at Seagull distributors.)
If you are going to install a pilot gure,
please use a sanding bar to sand the base
of the gure so that it is at.
3) Position the pilot gure on the canopy
oor as shown. Use epoxy to glue the base
of the pilot gure to the cockpit oor,
please see pictures as shown.
Glue the cockpit instrument panel in
place with C/A glue, please see pictures
as shown.
Epoxy.
150mm
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the
fu¬selage using a felt-tipped pen. Care-
fully cut and remove covering mate-
rial from the fusealge where the canopy
makes contact, exposing the bare wood.
e permanently glue the canopy in place
with epoxy glue or special “canopy glue”.
Epoxy.
e decals are sticky-back type. Most
are factory die-cut to shape. If you want
to trim the edges closer, use a sharp #11
hobby knife. Small decals can be applied
by simply removing the paper backing
sheet, and then lay the decal in position.
APPLY THE DECALS.