User Manual

NIEUPORT 28 REPLICA
Instruction Manual.
14
1) Tape the cowl to the fuselage using
low-tack tape.
2) Use a drill and drill bit to drill the holes
for the cowl mounting screws. Make sure
the cowl position is correct before drilling
each hole.
3) With the muer, needle valve, and
spark/ glow plug removed from the en-
gine, slide the cowl in place over the en-
gine. Temporarily install the propeller
and spinner in order to d the exact loca-
tion of the cowl. When satised with the
cowl placement, secure the cowl to the
fuselage using masking tape.
4) Install the muer and muer exten-
sion onto the engine and make the cutout
in the cowl for muer clearance. Connect
the fuel and pressure lines to the carbu-
retor, muer and fuel ler valve. Secure
the cowl to fuselage using the M3x10mm
socket head screws.Putting a small length
of silicon fuel tube under the head of the
screw helps with vibration.
6.
7.
4.
5.
8.
Because of the size of the cowl, it may be nec-
essary to use a needle valve extension for the
high speed needle valve. Make this out of suf-
cient length 1.5mm wire and install it into
the end of the needle valve. Secure the wire in
place by tightening the set screw in the side of
the needle valve.
9.
M3x10mm