User Manual

41
2) Use a 2.5mm hex wrench to remove the
screws that attach the panels to the fuse-
lage and center section. Slide the panels
from the tubes and disconnect the servo
lead for the aileron servo.
3.
2.
Using the transport frames allow the re-
moval of the wings without the need to
remove the aileron linkage and the inter-
plane strut between the top and bottom
wings.
4.
5.
1.
INSTALLING THE BATTERY-RECEIVER.
1) Plug the servos leads and the switch
lead into the receiver. Plug the battery
pack lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect
them from vibration.Mount as far for-
ward as possible.
Battery.
Receiver.
1) If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily ngerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and aid
in their location.
APPLY THE DECALS.
2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
gerprints and dust. Position decal on the
model where desired, using the photos on
the box and aid in their location.