User Manual

7
2) Secure the servos with the screws
provided with your radio system.
.
INSTALLING THE FUSELAGE SERVOS.
.
Because the size of servos dier, you
may need to adjust the size of the precut
opening in the mount. e notch in the
sides of the mount allow the servo lead to
pass through.
1) Install the rubber grommets and brass
collets into all servos. Test t the servos
into the fuselage servo mounts.
Elevator servo.
rottle servo.
Rudder servo arm.
rottle servo arm.
THROTTLE SERVO ARM
INSTALLATION.
Install adjustable servo connector in the
servo arm as same as picture below:
1.
1.
2.
Rudder servo.
Elevator servo.
Elevator servo arm .
Elevator servo arm.
INSTALLING THE RECEIVER SWITCH.
Install the switch into the precut hole in
the side, in the fuselage.
3/32” Hole.
.
INSTALLING THE ENGINE SWITCH.
Trim and cut.
Switch.
1.
2.
3.
Trim and cut.
1.