User Manual

55
4.
3.
Epoxy.
If all the decals are not precut, please use
scissors or a sharp hobby knife to cut the
decals from the sheet. Please be certain
the model is clean and free from oily n-
gerprints and dust. Position decal on the
model where desired, using the photos
on the box and aid in their location.
APPLY THE DECALS
BALANCING
It is critical that your airplane be
balanced correctly. Improper balance will
cause your plane to lose control and
crash. THE CENTER OF GRAV-
ITY IS LOCATED 125-145MM BACK
FROM THE LEADING EDGE OF
THE WING AT THE WING ROOT.
Mount the wing to the fuselage. Place a
piece of masking tape on the top of each
wing 145mm back from the leading edge
at the wing root.
If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily ngerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and
aid in their location.
With the model inverted, place your n-
gers on the masking tape and carefully
li the plane. is is the point at which
your model should balance for your rst
ights. Later, you may wish to experi-
ment by shiing the balance up to 10mm
forward or back to change the ying
characteristics. Moving the balance for-
ward may improve the smoothness and
arrow- like tracking, but it may then re-
quire more speed for take o and make it
more dicult to slow down for landing.
Moving the balance a makes the model
more agile with a lighter and snappier
”feel”. In any case, please start at the loca-
tion we recommend.
*If possible, rst attempt to balance the
model by changing the position of the re-
ceiver battery and receiver. If you are un-
able to obtain good balance by doing so,
then it will be necessary to add weight to
the nose or tail to achieve the
proper balance point.
With the wings attached to the fuselage,
all parts of the model installed ( ready to
y), and empty fuel tanks, hold the mod-
el at the marked balance point with the
stabilizer level.