User Manual

7
Use a pin vise and 3/32-inch (2mm) drill
bit to clear the paint from the ap control
horn.
5.
7.
6.
Route the servo lead for the ap servo out
at the root of the wing. Connect the ap
servo to the radio system. With the radio
system on, place the ap servo into posi-
tion.
Attach the clevis to the ap servo arm.
8.
Adjust the linkage so the ap is in the
mid-ap position. It may take a few tries
to properly adjust the linkage.
9.
Once adjusted, make sure all clevis re-
tainers are in position. Apply a drop of
threadlock near the clevis, then tighten
the nut against the clevis to keep the link-
age from changing length inside the wing.
10.
3x10mm.