User Manual
SHOCK CUB 35-55cc
Instruction Manual.
26
3.
4.
When cutting through the covering
to remove it, cut with only enough pressure
to only cut through the covering itself. Cut-
ting into the balsa structure may weaken
it.
Using a modeling knife, carefully remove
the covering that overlaps the stabilizer
mounting platform sides in the fuselage.
Remove the covering from both the top
and the bottom of the platform sides.
Slide the stabilizer partially into the
fuselage so the wood at the center is ex-
posed. Mix 1/2 ounce (15ml) of 30-min-
ute epoxy. Use an epoxy brush to apply
the epoxy to the exposed wood on the
top of the stabilizer.
Carefully turn the model over and apply
epoxy to the exposed wood on the bot-
tom of the stabilizer. Slide the stabilizer
back into position.
Use care not to get epoxy on the eleva-
tor joiner wire.
5.
6.
7.
Once the alignment of the stabilizer
has been verid, use a paper towel and
isopropyl alcohol to remove any excess
epoxy from the fuselage and stabilizer.
Allow the epoxy to fully cure before pro-
ceeding.