User Manual

SHOCK CUB 35-55cc
Instruction Manual.
6
INSTALL FLAP CONTROL HORN
Install the ap control horn using the
same method as same as the aileron con-
trol horns.
Place low-tack tape 1/32 inch (1mm)
from the control horn slot. is will pre-
vent epoxy from getting on the control
surface when the control horns are glued
in place.
Apply epoxy to the area of the control
horns that st into the slots. Use enough
epoxy so the control horns will be fully
bonded to the ed surfaces.
Before the epoxy fully cures, remove the
tape from around the control horn. is
will allow the epoxy to ow around the
control horn, creating a small let be-
tween the control horn and surface for a
ished look and secure bond.
Remove the control horns from the
control surfaces. Apply epoxy to the slot
in the aileron and ap. Make sure the
epoxy gets into the slot for a good bond
between the surfaces and control horn.
Fiberglass control horn
4.
5.
7.
1.
6.
Epoxy
Epoxy