User Manual

7
INSTALLING THE AILERON SERVOS
Because the size of servos dier, you
may need to adjust the size of the precut
opening in the mount. e notch in the
sides of the mount allow the servo lead to
pass through.
Place the servo between the mounting
blocks and space it from the hatch. Use a
pencil to mark the mounting hole loca-
tions on the blocks.
Use drill bit in a pin vise to drill the
mouting holes in the blocks.
Apply 2-3 drops of thin C/A to each
of the mounting holes. Allow the C/A to
cure without using accelerator.
Epoxy
2.
3.
1.
2.
3.
4.
Flap control horn
Minimum servo spec.
Torque : 122 oz-in (8.8 kg-cm) @ 6.0V;
139 oz-in (10.0 kg-cm) @ 7.4V