User Manual

WWW.SEAGULLMODELS.COM
27
4) When you are sure that everything
isaligned correctly, mix up a generous
amount of Flash 30 Minute Epoxy. Apply
a thin layer to the mounting slot and to
bottom of the vertical stabilizer mount-
ing area. Apply epoxy to the bottom and
top edges of the ller block and to the
lower hinge also. Set the stabilizer in
place and realign. Double check all of
your measurements once more before the
epoxy cures. Hold the stabilizer in place
with T-pins or masking tape and remove
any excess epoxy using a paper towel and
rubbing alcohol. Allow the epoxy to fully
cure before proceeding.
C/A glue.
Hinge.
1) Locate items necessary to install eleva-
tor pushrod.
Elevator control horn.
2) Elevator pushrods assembly as pic-
tures below.
ELEVATOR PUSHROD INSTALLATION.
HINGING THE RUDDER.
Glue the rudder hinges in place using
the same techniques used to hinge the ai-
lerons.
Fiberglass control horn
Epoxy.
Rudder berglass control horn.
INSTALL RUDDER CONTROL HORN.
Repeat steps to install the rudder control
horn as same as steps done for ailerons.