User Manual

North American T-28 Trojan
Instruction Manual.
30
.
INSTALLATION PILOT AND CANOPY.
1) Locate items necessary to install pilot,
seats.
2) A scale pilot is included with this ARF.
e Seagull Pilot included tting well to
the cockpit. (or you can order others scale
pilot gures made by Seagull factory.
ey are available at Seagull distributors.)
If you are going to install a pilot gure,
please use a sanding bar to sand the base
of the gure so that it is at.
3) Position the pilot gure on the can-
opy oor as shown. Use epoxy to glue
the base of the pilot gure to the cockpit
oor, please see pictures as shown.
Epoxy.
Epoxy.
Epoxy.
20mm
20mm
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the fu-
selage using a felt-tipped pen. Carefully
cut and remove covering material from
the fuselage where the canopy makes
contact, exposing the bare wood. en
permanently glue the canopy in place
with epoxy glue or special “canopy glue”.
Epoxy.