User Manual

WWW.SEAGULLMODELS.COM
15
COWLING.
1) Slide the berglass cowl over the en-
gine and line up the back edge of the cowl
with the marks you made on the fuselage
then trim and cut as shown.
Cut.
Cut.
2) While keeping the back edge of the
cowl ush with the marks, align the front
of the cowl with the cranksha of the
engine. e front of the cowl should be
positioned so the cranksha is in near-
ly the middle of the cowl opening. Use
the spinner backplate as a guide. Hold
the cowl rmly in place using pieces of
masking tape.
Because of the size of the cowl, it may be nec-
essary to use a needle valve extension for the
high speed needle valve. Make this out of suf-
cient length 1.5mm wire and install it into
the end of the needle valve. Secure the wire in
place by tightening the set screw in the side of
the needle valve.