User Manual

ZLIN 50. Instruction Manual
26
1.
2.
2.
1.
 10) Elevator and rudder pushrods assembly follow pictures below.
Elevator.
Rudder.
Throttle.
MOUNTING THE TAIL WHEEL.
Locate items necessary to install tail gear.
M3 x 12mm.
1.
2.
 11) Install servos arm to servos. Notice
the position of the servo arms on the servos.
See picture below.
Rudder pushrod.
Elevator pushrod.
 3) Secure the tail wheel bracket in place
using two M3 x 12mm wood screws. Be care-
ful not to overtighten the screws.
 1) Set the tail wheel assembly in place on
the plywood plate. The pivot point of the tail
wheel wire should be even with the rudder
hinge line and the tail wheel bracket should
be centered on the plywood plate.
 2) Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
Cut.