User Manual

ZLIN 50. Instruction Manual
28
Tighten the antenna.
Use the two wing bolts to attach the wing to
the fuselage. Make sure the distance between
a point centered at the rear of the fuselage and
each wing tip. The measurement will be equal
if the wing is aligned correctly. If the measure-
ment is not the same, slightly the hole for the
wing bolts until an equal measurement is
achieved.
ATTACHMENT WING TO FUSELAGE.
Wing bolt.
INSTALLING THE BATTERY-RECEIVER.
Receiver.
 1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery pack
lead into the switch also.
 3) Route the antenna in the antenna tube
inside the fuselage and secure it to the bot-
tom of fuselage using a plastic tape.
APPLY THE DECALS.
1) If all the decals are precut and ready to
stick. Please be certain the model is clean and
free from oily fingerprints and dust. Position
decal on the model where desired, using the
photos on the box and aid in their location.
2) If all the decals are not precut, please use
scissors or a sharp hobby knife to cut the
decals from the sheet. Please be certain the
model is clean and free from oily fingerprints
and dust. Position decal on the model where
desired, using the photos on the box and aid
in their location.
 2) Wrap the receiver and battery pack in
the protective foam rubber to protect them
from vibration.
 4) The last detail is to install the antenna
onto the fuselage. Use a hobby knife to cut a
slot in the top of the fuselage for the antenna.
 5) Tighten the antenna to the fuselage.
The antenna is removeable so you can install
it at the flying field to prevent damage in trans-
porting.