User Manual

www.seagullmodels.com
3
ADDITIONAL ITEMS REQUIRED.
 .75- .91 cu.in 2-stroke engine
.91- 1.00 cu.in 4-stroke
 5 digital servos
 Glow plug to suit engine
 Propeller to suit engine
 Protective foam rubber for radio
system
 Silicone fuel line
TOOLS & SUPPLIES NEEDED.
 Thick cyanoacrylate glue
 30 minute epoxy
 5 minute epoxy
 Hand or electric drill
 Assorted drill bits
 Modelling knife
 Straight edge ruler
 2mm ball driver
 Phillips head screwdriver
 220 grit sandpaper
 90° square or builder’s triangle
 Wire cutters
 Masking tape & T-pins
 Thread-lock
 Paper towels
1 Fuselage
2 Canopy
3 Left wing panel
4 Right wing panel
5 Tail set
6 Aluminum wing tube
7 Scale pilot
8 70mm wheels (2)
8.1 Tail wheel gear
8.2 Main landing gear
9 Wheel pants (2)
10 Decal sheet
11 EP conversion pack
12 Hardware bag included
13 Fiberglass cowl
 2) Remove each hinge from the wing panel
and aileron and place a T-pin in the center of
each hinge. Slide each hinge into the wing
panel until the T-pin is snug against the wing
panel. This will help ensure an equal amount
of hinge is on either side of the hinge line when
the aileron is mounted to the aileron.
The control surfaces, including the
ailerons, elevators, and rudder, are
prehinged with hinges installed, but the
hinges are not glued in place. It is
imperative that you properly adhere the
hinges in place per the steps that follow
using a high-quality thin C/A glue.
Note:
HINGING THE AILERONS.
Hinge.
T- pin.
 1) Carefully remove the aileron from one
of the wing panels. Note the position of the
hinges.
 3) Slide the wing panel on the aileron until
there is only a slight gap. The hinge is now
centered on the wing panel and aileron.
Remove the T-pins and snug the aileron
against the wing panel. A gap of 1/64” or less
should be maintained between the wing panel
and aileron.
KIT CONTEN.TS