Technical Specifications

PRODUCT
DATA SHEET
DESCRIPTION: Penetrating clear satin primer/sealer primarily for vertical
surfaces; water-based acrylic, low odor and low VOC.
Typical Uses:
3 Seal brick, stucco & concrete 3Rejuvenate old brick & plaster
3 Brighten aluminum siding 3Prime vinyl siding
3 Bind chalky surface 3Paint additive to extend life & coverage
3 Buffer pH in hot cement 3Dustproofing and priming floors
prior to painting
Important: Read all directions thoroughly. Recommended: Wear gloves and
safety glasses.
SURFACE PREP*: Surface must be clean and dry. Remove loose paint and
excessive chalk. Repair cracks and surface breaks. Cover windows, doors,
etc. and use caution when applying on windy days.
APPLICATION: Read “LIMITATIONS” section before use. This sealer is
ready to use; do not dilute. Apply with a brush, roller or sprayer (garden or
airless). Backroll spray applications to ensure penetration. Apply at least two
coats, allowing two hours dry time between coats. Remove any overspray
immediately with water. Note: Sealer goes on milky white but dries clear.
COVERAGE: 80–300 sq.ft. per gal., depending on surface porosity. Second
coat application is 50% greater. Two coats are required for waterproofing
bare, vertical concrete.
DRY TIME: 2–4 hours, depending on temperature and humidity.
TOPCOATING: May be topcoated with latex, oil-based or elastomeric coating
when dry.
PAINT ADDITIVE: 4–8 oz. of SEAL-KRETE Original can be mixed with one
gallon of latex paint to improve spread rate.
CLEAN-UP & STORAGE: Clean all tools immediately after use with soap and
water. Store unused product in a dry place above 32°F (0°C). KEEP FROM
FREEZING.
LIMITATIONS: Use on above grade vertical surfaces or as a primer on
horizontal surfaces – not for below grade use. Do not apply if rain is expected
within 12 hours or if temperatures fall below 50°F within 24 hours of
application. Do not use on swimming pools, bird baths, water features, cedar,
redwood or in areas where hydrostatic pressure is likely to develop. Do not
use on very porous substrates like low density, decorative block (use SEAL-
KRETE Heavy-Duty instead).
*Sanding or removing paint containing lead may be hazardous. For
information contact the National Lead Information Center at 1-800-424-LEAD
or www.epa.gov/lead.
CAUTION: Avoid contact with eyes and prolonged contact with skin. Do not
ingest. In case of eye contact, flush thoroughly with water. For skin contact,
wash with soap and water. If swallowed, do not induce vomiting. Drink 1–2
glasses of water and get medical attention.
KEEP OUT OF REACH OF CHILDREN.
Original 100001 1 gallon 0 15944 10001 3 1 00 15944 10001 0 15 x 9.5 x 13 1.07 / 36.43 4 36 cs
Original 100005 5 gallon 0 15944 10005 1 – – 1.30 / 44.92 1 36 ea
Carton Size Cube / Wt.
Product No. Unit UPC Code Carton Bar Code ( W x D x H ) ( cubic ft / lbs ) Carton Qty Pallet Qty
ORIGINALORIGINALORIGINAL
WATERPROOFING PRIMER/SEALER
WATERPROOFING PRIMER/SEALER
THE MOST VERSATILE
WATERPROOFING PRIMER/SEALER AVAILABLE
STUCCO
VINYL
BRICK
CONCRETE
BLOCK SIDING
www.seal-krete.com