Use and Care Manual
PRODUCT
DATA SHEET
DESCRIPTION: Ready-to-use premium low-gloss sealer that penetrates
deeply to seal and protect painted, stained or bare concrete. It goes on milky
white and dries to a low gloss finish, enhancing the natural character of your
surface. CLEAR-SEAL is a durable urethane-fortified acrylic sealer with low
odor, and low VOCs, so it’s easy to work with and safe for the environment. It
has excellent chemical resistance and repels stains.
Typical Uses:
3 Pool Decks 3Patios & porches 3 Driveways & Garages
Important: Read all directions thoroughly. Recommended: Wear gloves and
safety glasses.
SURFACE PREP*: Note: The surface should be clean and dry. You may need
an oil stain remover such as SEAL-KRETE
®
Oil Stain Remover to lift stubborn
oil stains. Pressure-washing is recommended.
Bare Concrete: Concrete must have cured for a minimum of 30 days.
Etch smooth-finished concrete, such as basement or garage floors with a
concrete etching solution like SEAL-KRETE Clean-N-Etch. Note: If etching
with muratic acid the area must be neutralized before proceeding. For
more information visit www.seal-krete.com.
Painted Surfaces: For use over one-part water-based coatings only;
not recommended over acid-based stains or oil-based coatings.
Freshly painted or stained surfaces must have cured for a minimum of
72 hours. Painted surfaces must be sound (not blistering or peeling).
Existing painted surfaces should be cleaned with a solution of Trisodium
Phosphate (TSP) and water. Rinse well and allow to dry.
APPLICATION: Read “LIMITATIONS” section before use. This product is ready
to use; do not dilute. Stir gently; do not shake. Apply in light, even coats. One
coat is recommended; however, over porous surfaces, like saltillo tile, or
when a higher sheen is desired, apply a second coat. Note: Sealer goes on
milky white but dries clear.
Roller: Dampen roller, remove excess water, then saturate roller with
product. Keep a wet edge while rolling. Do not allow to puddle, foam or
run. (Use a 1/4” nap for smooth surfaces, 3/8” nap for rough or porous
surfaces.)
Pump Sprayer: Set at a fine spray and apply using a circular motion.
To eliminate puddling or to achieve a more uniform finish, backroll
immediately after spraying.
COVERAGE: 150-500 sq.ft. per gallon, depending on surface porosity.
DRY TIME: Dry to touch in 1 hour (77°F, 50% RH). Recoat in 2 hours. Dry to
foot traffic in 24 hours. Will accept vehicular traffic in 72 hours. Dry times
should be extended in cooler temperatures or during high humidity conditions.
CLEAN-UP & STORAGE: Clean tools with soap and water immediately after
use. Store in a dry area. KEEP FROM FREEZING.
MAINTENANCE: Clean with a mild soap and water solution. Do not use
solvent-based cleaners.
LIMITATIONS: Temperatures should be 50° to 90°F and should not fall below
50°F within 24 hours of application. Do not apply if rain is expected within 12
hours. Do not use over acid-based stains, 2-part epoxies or oil-based paints.
Do not use on glazed tile. Do not use in areas subject to hydrostatic pressure.
Smooth-finished concrete may be slippery when wet; consider using an anti-
skid additive like SEAL-KRETE Clear Grip on high foot traffic areas.
*Sanding or removing paint containing lead may be hazardous. For information
contact the National Lead Information Center at 1-800-424-LEAD or www.
epa.gov/lead.
CAUTION: KEEP OUT OF REACH OF CHILDREN.
FIRST AID: For Eye Contact: Flush with water for 15 minutes. For Skin
Contact: Prolonged contact may cause irritation. Wash affected area with
soap and water. If Swallowed: Induce vomiting and seek immediate medical
attention. If Inhaled: If headache or nausea is experienced, remove the
individual to fresh air. If symptoms persist, seek medical attention.
Clear-Seal
365001 1 gallon 0 15944 36501 6 1 00 15944 36501 3 14 x 14 x 8 .91 / 39 4 45 cs
Carton Size Carton Size
Product No. Unit UPC Code Carton Bar Code ( L x W x H ) ( cubic ft / lbs ) Carton Qty Pallet Qty
PREMIUM LOW GLOSS SEALER
PREMIUM LOW GLOSS SEALER
CLEAR-SEALCLEAR-SEAL
CLEAR-SEAL
www.seal-krete.com