User manual
English
5.1.1.4 The Nip Screen
The rolls on the 65Pro MD are pneumatically raised and lowered. The position that the
rolls move to when they are lowered is controlled by electronically moving a stop that holds
the rolls open to any position that the user enters. In order to change the nip setting, the
rolls must be in the raised position.
Similar to heater settings, the nip height can be directly typed into the blue calculator, or
you can use pre-sets. One other method is to use fractions. The purple arrow allow for
adjustments of 1/100 inches. The number near the top of this menu indicates the current
pressure setting, in this example 35%. The pressure is controlled by manual dials on the
laminator but is indicated on this screen and the Home screen.
• There are two nip screens – a main roll nip screen and a pull roll nip screen.
• These screens are entered by pressing either nip button in the main screen.
• The only differences in the two screens are the icons, the current set point displayed in the
nip height display, and the current pressure being displayed under the slider icon.
• This screen will remain open until the check mark is pressed or for 15 seconds of inactivity.
After that, the screen will revert to the Home screen.
Machine Operation 31