EN Macerator Toilet Installation DE Elektrische Toilette Installation . . . . . . . . . . . . . . . . . . . . 13 FR WC dilacérateur Installation . . . . . . . . . . . . . . . . . . . . . 23 ES Inodoro triturador Instalación . . . . . . . . . . . . . . . . . . . . . 32 NL Toilet met versnijdingspomp Installatie . . . . . . . . . . . . . . . . . . . . . . 41 IT WC di macerazione Installazione . . . . . . . . .
SeaLand MasterFlush Toilet 1 B E A D C F G H I L J K 4 2 B C F A A D B E C 3 A 1 2 3 4 B 2 C
SeaLand MasterFlush Toilet Notes on using the manual Table of contents 1 2 3 4 5 6 1 EN Notes on using the manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 General safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 4 Components . . . . . . . . . . . . . . . . . . . .
General safety instructions SeaLand MasterFlush Toilet Caution! Hazard of Flooding If toilet is connected to ANY through-the-hull fittings, ALL flexible hoses must be of marine sanitation quality and must be secured to ANY fittings (such as those at seacock, vented loop or toilet) with two stainless steel, worm-drive hose band clamps at each connection. Connections MUST be checked frequently for integrity. Failure to comply can result in flooding which can cause loss of property and life.
SeaLand MasterFlush Toilet 3 Components Toilet system (fig. 1 , page 2) Ref. Components 5 1 Description A Macerator toilet B Dometic DFT flush switch C Control module D 4-wire cable to toilet macerator pump and water valve E Dometic DFT touchpad, DFS or DFP flush switch cable F Cable for previous flush switch connections (discontinued models) G Incoming electrical power wires H Power wires to raw water pump (opt.
Specifications SeaLand MasterFlush Toilet 4 Specifications 4.1 Materials Toilet: vitreous ceramic Dometic DFT switch panel frame: ABS Macerator pump body: glass-filled polypropylene Dometic DFT switch panel: polycarbonate resin Control module housing: ABS 4.2 Minimum System Requirements Electrical Water Supply Discharge Circuit breaker 20 amps/12 V DC; 15 amps/24 V DC Wiring 12 ga. (up to 20 ft./6.1 m from breaker) Fitting 0.5 in. NPT Flow rate 2.0 gpm/7.
SeaLand MasterFlush Toilet Models 8670, 8679, 8680, 8689 (standard height) Ref. Dimension Specifications Models 8630, 8639, 8640, 8649 (low-profile height) Ref. Dimension A 18 in. / 457 mm A 15 in. / 381 mm B 14.75 in. / 375 mm B 14.75 in. / 375 mm C 19.75 in. / 502 mm C 19.75 in. / 502 mm D 17 in. / 432 mm - seat height D 14 in. / 356 mm - seat height E 16 in. / 406 mm E 15.375 in. / 391 mm F 33.5 in. / 851 mm - seat lid up F 30.5 in.
Installation SeaLand MasterFlush Toilet 5 Installation 5.1 Fresh water system layout SeaLand macerator toilets can operate with an onboard pressurized freshwater system with a minimum flow rate of 2.0 gpm (7.6 lpm) at the toilet. Onboard fresh-water demand systems include a water pump that automatically draws water from a water storage tank when a valve DECK DISCHARGE 8 FLUSH SWITCH “FULL” LEVEL PROBE (opt.) DISCHARGE PUMP VENT FITTING anywhere in the piping system is opened.
SeaLand MasterFlush Toilet Installation Caution! Hazard of Flooding If toilet uses raw water for flushing at ANY time, a raw water pump controlled by an automatically operating demand switch MUST NOT be installed. If the onboard water valve or any plumbing connections were to leak, the automatically operated pump would start and could flood the boat. Failure to comply with this warning can cause loss of property and life. 5.3 Toilet system with through-the-floor connections 1.
Installation SeaLand MasterFlush Toilet 11. Route water supply and discharge plumbing to toilet according to system requirements (Section 4.2). Make sure to provide extra discharge hose length to assure easy connection to toilet (fig. 14 ). 12. Loosen band clamp on discharge loop outlet and remove discharge adapter fitting/hose fitting assembly (fig. 15 ). 13. Lubricate discharge fitting assembly and inside end of discharge hose with liquid dishwashing soap.
SeaLand MasterFlush Toilet 5.4 Toilet system with through-the-wall connections Installation 20 1. To route wiring and plumbing connections through the wall, use floor template to locate the vertical centerline of each hole. 2. Place toilet in proper position and mark horizontal centerlines (fig. 20 ). 3. Drill holes sizes as indicated on template. 4. Route wiring and plumbing through holes according to system requirements (Section 4.2).
Installation 6 SeaLand MasterFlush Toilet Customer service There is a strong, worldwide network to assist in servicing and maintaining your toilet system. For the Authorized Service Center near you, please call from 8:00 a.m. to 5:00 p.m. (ET) Monday through Friday. You may also contact or have your local dealer contact the Parts Distributor nearest you for quick response to your replacement parts needs. They carry a complete inventory for the SeaLand product line.