EN Tank Monitor Instruction manual DTM01 Tank Monitor
DTM01 Tank Monitor 1 3 2 1 2 3 2 2 1 4 4
DTM01 Tank Monitor Notes on using the manual Table of contents 1 2 3 4 5 6 7 8 1 Notes on using the manual General safety instructions Intended use Components and functions Specifications Installation Warranty and product liability Customer service EN 3 3 4 4 5 6-9 11 - 12 12 Notes on using the manual Caution! Safety Instruction: Failure to observe this instruction can cause material damage and impair the function of the device. Note Supplementary information for operating the device. fig.
Intended use 3 DTM01 Tank Monitor Intended use (fig. 1 , page 2) DTM01 Tank Monitor panel indicates when a wastewater holding tank is almost full. This monitor helps prevent damage to the boat that can happen because of accidental overfilling of the holding tank. Caution! Do not use in fuel tank. 4 Components and functions Item (fig.
DTM01 Tank Monitor 5 Specifications 5.1 Materials Panel frame: ABS Panel: Polyester 5.2 Specifications Float switch: Nitrile rubber ebonite Electrical Current Draw Average current consumption: 0.016 amps at 12 V DC. Requires 0.5-amp fuse. 5.3 Approvals ISO8846; EMC Directive 2004/108/EC 5.4 Dimensions 2.5 in. (64 mm) 2 in. (51 mm) 3.25 in. (83 mm) 4.5 in. 3.94 in. (114 mm) (100 mm) 0.375 in. (10 mm) 2 in. (51 mm) min.
Installation 6 Installation 6.1 Indicator Panel (fig. 3 , page 2) DTM01 Tank Monitor Caution! Do not install indicator panel in an atmosphere with potentially flammable or explosive vapors. 1. Select panel location away from direct contact with water and oil. 2. Confirm clearance for wire connections behind wall, hull liner or bulkhead. 3. Using indicator panel template (fig. 6 , p. 9), cut out panel access hole and drill fastener holes. 4.
DTM01 Tank Monitor 6.2 Installation Probe Assembly (fig. 4 , page 2) Caution! Do not use probe assembly in fuel tank. Never install the probe assembly with float switch in tank that contains anything other than wastewater, gray water or fresh water. Note For installation in sailboats: Locate probe assembly on athwartships centerline of tank to assure accuracy when heeled. 1. Route 18-gauge stranded copper wire from DC Ground source to probe assembly. 2.
DTM01 Tank Monitor THIS PAGE IS INTENTIONALLY BLANK.
DTM01 Tank Monitor Indicator panel template 6 9
DTM01 Tank Monitor THIS PAGE IS INTENTIONALLY BLANK.
DTM01 Tank Monitor 7 Warranty Warranty and product liability North America Manufacturer’s One-Year Limited Warranty Dometic Corporation, Sanitation Systems (Dometic) warrants to the original purchaser only that this product, if used for personal, family or household purposes, is free from defects in material and workmanship for a period of one year from the date of purchase.
Warranty DTM01 Tank Monitor Europe: Warranty Warranty arrangements are in accordance with EC Directive 44/1999/CE and the normal conditions applicable for the country concerned. For warranty or other service, please contact our Dometic Service department listed elsewhere in this manual. Any damage due to improper use is not covered by the warranty.
