Installation Instructions

PREMIUM RUBBERIZED
FOUNDATION COATING
DRIES BLACK
Uses:
•
Coating
•
Waterproofing
•Priming
•
 ExteriorBasement
Walls
•
 Polystyrene/Styrofoam
Insulation Board
•
Concrete Walls
 (BlockorPoured)
•
 Foamboard
•
Wood
•
 &OtherSurfaces
ECOFriendlyFormulationECOFriendlyFormulation
DIRECTIONS
Surface shall be clean, dry and free of any dirt or contaminants. Application
temperature must be a minimum of 60 ºF and rising. Do not apply when
temperature is expected to drop below 50 ºF within a 24-hour period. Be sure
to wear eye protection and gloves when mixing and applying this product. In
areas where dew or fog accumulates in the early evening, it is best to coat in the
morning. Stop coating by early afternoon (3:00 pm) to prevent wash off, which
will occur if dew, fog, or rain arrives before coating dries. Do not apply if rain is
imminent or forecast within 24 hours of application. Stir container thoroughly.
Apply using either a brush, roller, or airless spray unit (suggested tip size .021
to .025). Apply material at a rate of 150 square feet per 4.75 gallon pail. Allow
material to dry and cure for 24 hours prior to application of foam or drainage
boards or backlling. Clean tools with water before material dries.
COVERAGE
Approximately 150 square feet per 4.75 gallon pail at 60 mils thickness.
DRYING TIME
Allow 24 hours depending on weather conditions.
CAUTION
Avoid breathing vapors and contact with eyes and skin. Do not take internally.
Clean hands thoroughly after using. Exterior use only.
KEEP OUT OF REACH OF CHILDREN.
FIRST AID
IN EYE: Immediately ush with large amounts of water for at least 15 minutes.
Immediately seek medical attention.
ON SKIN: Wash thoroughly with soap and water or hand cleaner (if material has
dried). If irritation or rash develops, seek medical attention.
IF INHALED: Remove person from exposure. If breathing has stopped or is
difcult, administer articial respiration or oxygen as needed. Seek medical aid.
IF INGESTED: Do not induce vomiting. Seek medical aid immediately.
PROTECT CONTAINER FROM FREEZING.
ATTENTION
Empty containers may retain material residues. Dispose of empty container
in accordance with local, state, and federal regulations based upon chemical
composition of contents.
VOC - ZERO
WARRANTY
The statements made on this container are believed to be true and
accurate and are intended to provide a guide for approved application
practices. As workmanship, weather, construction, condition of surface,
tools utilized, and other variables affecting results are all beyond our
control, the manufacturer warrants only that the material is free from
defects and any liability to the buyer or user of this product is limited to
the replacement value of the product only. The manufacturer expressly
disclaims any implied warranties of merchantability or tness for a
particular purpose.
CHEMICAL COMPOSITION
Water CAS # 7732-18-5
Polymer CAS # N/A
Asphalt CAS # 8052-42-4
Manufactured by:
ThorWorks Industries
2520 S. Campbell St.
Sandusky, OH 44870
1-800-326-1994
6 3 7 8 4 3 8 0 0 1 5 5
•LiquidRubberMembraneSeals&Water-ProofsConcrete,Wood,Foamboard&More
•Over300%Elongation-SuperiorResiliency&Flexibility
•AdvancedWater-BasedTechnology-ZEROVOC•BridgesSmallCracks
CAUTION: SKIN AND EYE IRRITANT
See back panel
ForMoreInstallationTips
Visitwww.Homedriveway.com
COVERAGE:
150sq.ft.per4.75gallonpail
4.75U.SGal.
(17.9L)
POLYMER-MODIFIED
ASPHALTEMULSION
FORSUPERIOR
WATERPROOFING