User Manual

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and

properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL

REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE

PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY

AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

INSTRUCTIONS FOR:

BEARING RACE & SEAL

DRIVER SET - 10 PIECE

Model No: VS703.V5

1. SAFETY INSTRUCTIONS

 WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered

to when using this equipment.

 WARNING! Always wear approved eye protection when using the driver. Failure to do so may result in serious

injury. Normal spectacles are not adequate protection.

 Familiarise yourself with the specific applications and limitations of the driver, as well as any potential hazards.

 If unsure of the applications or limitations of the driver, contact your supplier.

 Ensure that the driver is the correct tool for the task. DO NOT use the driver for any purpose other than that

for which it is designed.

 Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will

invalidate the warranty.

 Ensure that the workpiece is stable and that there is adequate lighting.

 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.

 Use the correct size and type of hammer for the task. The recommended diameter of hammer face is 10mm

larger than tool head. Check that the hammer shaft is in good order and is firmly secured in the hammer

head. Note that for seal installation a soft-faced hammer should be adequate and will be less likely to

damage the tool.

 Make sure that the face of the hammer and the head of the tool are clean and free from grease, oil, etc.

 Position the tool so that it is struck away from your body.

 Strike the driver squarely on the head - DO NOT hit the tool off centre, or at an angle (fig.1).

 DO NOT use the driver if it is bent, chipped, has a mushroom head, or is otherwise damaged (fig.2).

 DO NOT strike the side of the driver body (fig.3).

 DO NOT use driver if any parts are damaged or missing as this may cause failure and/or personal injury.

 DO NOT use the driver when you are tired or under the influence of alcohol, drugs or intoxicating medication.

 Keep children and unauthorised persons away from the working area.

 When not in use, pack into the case, and store in a safe, dry, childproof location.

fig.3

fig.2

fig.1

Original Language Version

VS703.V5 Issue: 1 - 12/09/11

Incorrect

PAGE 1
Instructions for: BeaRING RACE & SEAL driver set - 10 piece Model No: VS703.V5 Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
PAGE 2
. OPERATION 2.1. Contents 2.1.1. Check the contents (see parts below) and contact your supplier if any items are missing or damaged. 2.2. Usage 2.2.1. Remove bolt (fig.4.B) from handle (fig.4.A). 2.2.2. Select the correct adaptor (fig.4.C), one which is slightly smaller than the diameter of the seal/bearing race, and position it correctly on the handle, secure it using the bolt. 2.2.3. Place the seal/bearing race (fig.4.E or F) in the mouth of the housing (fig.4.