User Manual

INSTRUCTIONS FOR
COIL SPRING COMPRESSOR
MODEL: RE2280
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS
AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO
DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS
SAFE FOR FUTURE USE.
 DANGER! Stop compressing the spring before the coil
windings touch.
 WARNING! Ensure Health & Safety, local authority,
and general workshop practice regulations are adhered
to when using this equipment.
 WARNING! Wear approved safety eye protection
(standard spectacles are not adequate).
 WARNING! Measure the outer diameter of the spring
to be compressed and select the correct set of jaws to
fit the spring.
 DO NOT operate spring compressor if parts are
damaged or missing as this may cause failure and/or
personal injury.
 DO NOT force the spring compressor to achieve a task
it is not designed to perform.
 DO NOT allow untrained persons to use the spring
compressor.
 Familiarise yourself with the applications, limitations
and potential hazards of the spring compressor.
 Maintain the spring compressor in good condition.
Replace or repair damaged parts. Use genuine parts
only. Unauthorised parts may be dangerous and will
invalidate the warranty.
 Keep the work area clean, uncluttered and ensure
there is adequate lighting.
 Keep hands and body clear of the spring when
operating the spring compressor.
 Maintain correct balance and footing. Ensure the floor is
not slippery and wear non-slip shoes.
 Remove ill fitting clothes. Remove ties, watches, rings,
other loose jewellery. Contain and/or tie back long hair.
 Wear appropriate protective clothing.
 When not in use clean and store the spring compressor
in a safe, dry, childproof location.
2. TECHNICAL SPECIFICATION
1. SAFETY INSTRUCTIONS
Maximum Spring Load: ...................................1250kg
Size/Suitability: ............................. (Ø80mm - 135mm)
Jaw Opening: ...........................................115-300mm
Drive: ......................................................... 19mm Hex
3. INTRODUCTION
3.1. Designed for use on wishbone suspension using
access points in the rear suspension arm.
Features two pairs of carefully shaped yokes that
prevent the coil spring from bowing.
Saves time over traditional methods of demounting
springs.
Fig.1
Original Language Version
RE2280 Issue: 1 - 7/6/10