User Manual

4. OPERATION
5. MAINTENANCE
4.1.4. Tighten the cap screw onto the spindle using the provided hex key, torque to approximately 10 ft-lb.
4.1.5. After securing, the attachment should not move on the spindle. If it can move with the power off, remount it, making sure that the holes
on the attachment line up with the pins on the spindle. Tighten the cap screw securely.
4.2. Work area set up
4.2.1. Choose a work area that is clean and well-lit. The work area must not allow access by children or pets. To prevent distraction and injury.
4.2.2. Route the mains cable along a safe route to reach the work area without creating a tripping hazard or exposing the mains cable to
possible damage. The mains cable must reach the work area with enough extra length to allow free movement while working.
4.3. Operation
4.3.1. Pull the On/Off switch back to its off position. Then plug the mains cable in.
4.3.2. To turn on the tool, slide the On/Off switch forward. DO NOT allow contact between the angled cutter, scraper or other accessory and
workpiece until the tool is running at full speed.
4.3.3. Avoid contact with foreign objects such as metal screws and nails when sanding, scraping, or cutting.
4.3.4. DO NOT apply excessive pressure on the tool. Allow the tool to do the work.
4.3.5. Whennished,turnoffthetoolandallowittocompletelystopbeforesettingitdown.Thenunplugthetoolfromitselectricaloutlet.
4.3.6. Prior to storing the tool, remove the attachment and wipe it clean. Store the Tool in a clean, dry, safe location out of reach of children and
other unauthorized persons.
fig.1
fig.2
fig.3
 WARNING! To prevent injury from accidental operation, turn the On/Off switch of the tool off and unplug the tool from its
electrical outlet before performing any inspection, maintenance or cleaning procedures.
 WARNING! To prevent serious injury from tool failure, DO NOT use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
5.1. Maintenance
5.1.1. Before each use, inspect the general condition of the Tool. Check for loose screws, misalignment or binding of moving parts,
cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation.
5.1.2. Inspect accessories, sanding sheets should not be dull or contain excessive debris build up. The angle scraper and cutting blade
should be clean and sharp.
5.1.3. After use clean external surfaces with a clean cloth.
5.1.4. Ifthetoolhasdecreasedperformance,havetheunitservicedandthecarbonbrushesreplacedbyaqualiedservicetechnician.
4.1. Tool set up
 WARNING! To prevent injury from accidental operation turn the power switch of the tool off and unplug the tool from its
electrical outlet before adjusting the tool or adding accessories.
4.1.1. Turn the power switch off and unplug the tool.
4.1.2. Place the attachment over the spindle, shoulder facing away from the tool. Line up the holes on the attachment with the pins on the
spindle shoulder.
Note:TheAngledCutterBladeshouldonlybeusedinthestraightaheadpositionandnotanangledposition,seeg.1.
4.1.3. Slide the small washer, then the large washer onto the cap screw. Make sure the cupped side of the large washer is toward the tool.
 Whileholdingtheattachmentoverthepinsonthetool,threadthecapscrewinplace,seeg.2.
Original Language Version
SMT180 Issue:1-04/12/14
© Jack Sealey Limited