User Manual

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly

maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND

CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY

CAUSE DAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

1. SAFETY INSTRUCTIONS

INSTRUCTIONS FOR:

STUD EXTRACTOR SET

MODEL No: VS7233

2. INTRODUCTION

3. CONTENTS

4. SIzE GUIDE CHART

7 Do not use the stud extractor set for any purpose other than for which it is designed.

3 Keep the kit free from dirt and grime.

3 Ensure your work area is tidy and free from hazards.

3 Ensure the correct sizes of guide and drill are used to avoid injury and damage to the set.

 WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover

all possible conditions and situations that may occur. It must be understood that common sense and

caution are factors which can not be built into this product, but must be applied by the operator.

VS7233 Issue No: 1 - 23/11/10

Original Language Version

Suitable for the removal of broken studs and bolts. Supplied with centring pilots for Ø4.75-9.75mm studs, drills,

extractor shafts and nuts. Ideal for engine manifold studs.

Stud size 4.0 4.75 4.75 4.75 6.1 7.2 7.2 7.2 9.0 9.75 12 15

Guide size B1 B2 B3 B4 B5 B6 B7 B8 B9 B10 - -

Guide ext. Ø 6.0 8.0 9.0 10.0 10.0 11.0 12.0 13.0 13.0 14.0 - -

Drill to use 3.2 3.2 3.2 3.2 4.8 4.8 4.8 4.8 6.4 6.4 8.0 8.9

Pin to use PIN 1 PIN 1 PIN 1 PIN 1 PIN 2 PIN 2 PIN 2 PIN 2 PIN 3 PIN 3 PIN 4 PIN 5

Hex extractor D1 D1 D1 D1 D2 D2 D2 D2 D3 D3 D4 D4

PAGE 1
INSTRUCTIONS FOR: STUD EXTRACTOR SET MODEL No: VS7233 Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
PAGE 2
5 . operation 5.1 5.2 5.4 5.5 5.6 5.7 5.8 5.9 Obtain a replacement for the broken stud or bolt first so that you know how deep to drill the pilot hole. Use the size guide chart overleaf to select the correct combination of drilling guide, pin and hex driver. Where a stud or bolt has sheared below the insertion surface select the largest drilling guide that fits into the hole as shown in fig.1A.