User Manual

51
Figure 6.13
6.2 Oil Reset
6.2.1 General Information
This section of the manual offers instructions on how to use the tool
to reset oil/service light. It is specially designed to reset oil service
light, oil inspection light, service mileage and service intervals.
All software screens shown in this manual are examples, actual test
screens may vary for each vehicle being tested. Observe the menu
titles and onscreen instructions to make correct option selections.
IMPORTANT: Always reset the engine oil life to 100% after
every oil change.
NOTE: All required work must be carried out before the
service indicators are reset. Failure to do so may result in
incorrect service values and cause DTCs to be stored by the
relevant control module.
NOTE: For some vehicles, the scan tool can perform added
functionality to reset additional service lights (maintenance
cycle, service interval).
6.2.2 Reset Operation
1. Turn the ignition on but do not start the engine.
2. With the scan tool in Select Mode screen, select Oil Reset, and
press OK button.
Erase Codes
Erase Failure.
Turn Key on with
Engine Off!
Press any key to continue