User Manual

50
4. If you do not want to erase the codes, press No function key or
ESC button to exit. A message of “Command cancelled” will
show up. (Figure 6.11)
Figure 6.11
5. If you do wish to erase the codes, then press Yes function key or
press OK button.
 If the codes are cleared successfully, an “Erase Done!”
confirmation message shows on the display.( Figure 6.12)
Figure 6.12
 If the codes are not cleared, then an “Erase Failure. Turn Key
on with Engine off!” message appears (Figure 6.13). Press any
button to return to the previous menu.
Erase Codes
Erase Done!
Press any key to continue .
Erase Codes
Command Cancelled.
Press any key to continue .