Instruction Manual

Original Language Version
© Jack Sealey Limited
3. SPECIFICATIONS
Model No: ........................................................... VS250
Supply: ................................................................... 230V
Frequency: ............................................................. 50Hz
Power: .................................................................2300W
Refer to g.2
1: VS2303:
......................................Direct Coil - Ø20mm
2: VS2305:
......................................Direct Coil - Ø30mm
3: VS2304:
........................................Side Coil - Ø20mm
4: VS2306:
........................................Side Coil - Ø30mm
5: VS2309:
.........................................Pad Coil - Ø55mm
6: VS2310:
......................................... Flex Coil - 920mm
7: VS23111: ........................... Induction Adaptor Ø29mm
4. FEATURES
4.1. DESCRIPTION OF CONTROLS refer to g.1
A) Power pilot light (green)
B) Over heated pilot light (red)
C) Output connector - for torch power
D) Output connector - for torch control
E) Timer Control:
Select ‘-’ Operate Trigger on torch, machine will work for 1 second, and then stop until trigger is
operated again.
Select ‘=’ Operate Trigger on torch, machine will work for 1.5 second, and then stop until trigger
is operated again. Select ‘0’ Operate Trigger on torch, machine will work continuously.
F) Torch
G) Main Power Switch (situated on back panel)
4.2. DESCRIPTION OF TORCH HEAD
1. Direct Coil Ø20mm
2. Direct Coil Ø30mm
3. Side Coil Ø20mm
Use Direct Coil/Side Coil to heat nuts/bolts, screws etc. Keep gap of 3/4mm between coil and object being heated.
8 DO NOT reuse bolts as heat may have e󰀨ected the physical properties of the bolt.
4. Side Coil Ø30mm
5. Pad Coil Ø55mm
Use Pad coil for heating of sheet steel to assist with the removal of decals, stickers, sealants/putties, use the coil approximately 5mm
away from the surface of the steel sheet.
 WARNING! Over heating will damage painted surfaces. No liability will be accepted for damage caused by improper use.
6. Flex Coil 740mm
Use Flex coil when it is not possible to use direct coils due to space, or position of object to be heated.
Can be used on exhaust pipes and suspension parts, by wrapping the coil around the part before connecting to the torch.
g.1
g.2
g.3
1 5
6
7
Trigger
2
4
VS250 Issue 2 (3) 23/03/2021
3