Instruction manual

TAKING SEA PICTURES, Cont.
Close Latch Test before Diving Dry with a clean towel
Keep camera housing in shade to
avoid over-heating inside of housing.
Remove Camera
from housing only when
you and the housing are
perfectly dry
22
23
ReefMaster DIGITAL Quick Guide
Closing the Housing
When closing the housing,
press the lid tightly down to ensure
a waterproof sea, before closing
the latch.Do not close the latch
if the lid is not completely
and tightly closed.
Clean O-Rings w/Brush
Insert Desiccant
Do not grease O-Ring
1. Power ON camera.
2.See object in LCD monitor.
3.Shoot - Hold camera steady;press shutter button
4.You may delete a picture within 3 seconds when prompted.
5.Turn power OFF camera to save battery power.
Note:If camera is not used for 3 minutes, the camera will go
into power save mode. To reactivate, push the shutter button
again.If camera is not used for 15 minutes, power will shut
OFF. To re-activate, press power button.
Soak or Wash
with fresh water
After diving rinse or soak camera in
housing with fresh water.
Never let sea water dry on camera housing.
Pioneer Quick Guide 11/13/01 10:06 PM Page 22