User's Manual

MUST DO for underwater housing:

1. Read these instructions before using the underwater housing.

2. Do not exceed the depth rating printed on the lens port of the housing.

3. Keep main O-Rings perfectly clean.

•Clean main O-rings with cleaning brush provided before every use. Do not remove O-rings. Do not

grease.

•Store camera and housing only after careful cleaning and when totally dry.

•Housing uses two large O-rings at housing sealing lid. Never use housing without both O-rings in place.

•If O-ring is damaged, contact the SeaLife Service Center. (See page 42)

•O-ring must be perfectly clean (no sand, dirt or debris) before sealing housing.

•Soak or rinse sealed housing with fresh water after drying.

4. Carefully close lid to seal housing.

•Make sure O-rings do not slip out of the groove when sealing.

•Press lid firmly and tightly down into housing to ensure a waterproof seal.

5. Never let any moisture or dirt get inside housing when opening.

•Only open and load the housing in dry cool air, such as inside an air-conditioned room.

6. For great underwater pictures you need:

•Clear water conditions, control your buoyancy before taking picture, get as close as possible to subject

(ideal distance is 2’ to 6’). Use the SeaLife Macro Lens/Filter for close-up pictures with super details

and vibrant colors.

7. Store housing at room temperature in a clean and dry place

•Do not expose housing to direct sunlight for prolonged periods of time.

•Do not store housing in hot locations, like the trunk of your car.

PIONEERmanREV 11/19/01 6:00 PM Page 40