User's Manual

24
Using the LCD monitor and QUICK REVIEW mode
1. Open the lens cover.
2. Turn the mode dial to mode.
3. Turn the camera on by pressing the button.
4. By pressing the button repeatedly in mode
when quick view is O N, the LCD status will
change cyclically.
LCD on and OSD • LC D on • LC D off
5. Press and hold LCD button for 3 seconds to activate Quick Review mode.
The last picture taken will be displayed. Use / buttons to scroll between
pictures in memory. Press and hold LCD button for 3 seconds to exit Quick
Review mode.
6. When camera is set to Flash mode, the LCD button is used to select between
MAC RO flash mode and FAR flash mode. Select MAC RO f lash mode for
shooting distance inside of 2’ ( 60cm ) and FAR flash for shooting distance
beyond 6’ ( 180cm ) .
• The image on the LCD monitor darkens when in strong sunlight or bright light. This is not a
malfunction.
• Using the LC D monitor for an extended period of time may reduce the number of shots
you can take. To conserve battery power and increase the number of shots you can take, turn
the LC D monitor off and use the viewfinder instead.
• Always use the image LCD for macro shots to avoid parallax error.
• The LCD monitor must be on when Digital zoom is to be used.
Setting Seascape focus for Land & Sea pictures
Set focus switch ( located under lens ) to the
position for the sharpest, most colorful pictures for
land and
underwater. The effective range is 6’ to
infinity, ( 1. 8m to infinity ) , for land pictures and
3. 5’ to infinity ( 1 meter to infinity ) for underwater
pictures.
1. Open the lens cover, turn the mode dial to
mode, and power on the camera.
2. Move the focus switch located on the front side of the camera to
the position.
3. C ompose the picture.
4. Press the shutter button.
• Use the Seascape focus ( position ) for underwater pictures for sharp pictures from 3. 5’
to infinity. For sharp pictures inside of 3’, use SeaLife macro lenses/filters ( optional ) .