Operation Manual

EN-53
Maintaining a waterproof seal
Every SeaLife camera is tested for quality and a waterproof seal. It is your responsibility
to properly care for the O-ring and O-ring contact surfaces to maintain a waterproof
seal. Carefully follow these important O-ring care instructions. Not following these care
instructions may cause the camera to leak and void your warranty.
1. Carefully inspect O-ring and O-ring contact surfaces for damage (cuts,
scratches, tears, cracks, dents and any other imperfections.) before every use
.
Rub finger along O-ring and O-ring contact surfaces to inspect for damage.
Replace O-ring or have camera serviced if the O-ring or O-ring contact surfaces
are damaged. Do not use camera if O-ring or O-ring contact surfaces are damaged.
Replacement O-rings are available at your local authorized SeaLife dealer.
Inspect and replace O-ring if damaged: A=Cut, B=Tear, C=Dent
2. Carefully inspect and clean O-ring and O-ring contact surfaces for sand, hair
and other debris before every use.
Inspect and clean O-ring and O-ring contact surface for hair or fibers (#1) and
Sand, Salt or debris (#2)
3. Make sure O-ring is completely seated into O-ring groove before sealing housing.
O-ring must not be twisted when seated in the o-ring groove.