Operation Manual

EN-76
TROUBLESHOOTING
Refer to the symptoms and measures listed below before sending the camera
for repairs. If the problem persists, contact your local reseller or SeaLife service
center in your country. For a complete listing of service centers in your country visit
www.SeaLife-cameras.com.
Power Supply
Symptom Cause Measure
The power does not
come on.
The batteries are not loaded. Load the batteries correctly.
The batteries are exhausted. Recharge or replace the batteries.
The power cuts out
during use.
The camera was left unattended
and unused, so the auto power off
cuts it off.
Turn the power back on.
The batteries are exhausted. Recharge or replace the batteries.
The power does not
go off.
Camera malfunction. Reload the batteries.
The batteries run
out quickly.
It is being used in extreme low
temperature.
Many shots are being captured in
dark places inside, requiring flash.
The batteries are not fully
charged.
The batteries are not used for
an extended period of time after
charged.
Fully charge the batteries and
discharge them for at least one
complete cycle before use to
maximize its performance and
lifetime.
The batteries or
camera feels warm.
Long period of continuous use of
the camera or the flash.