Service manual
Latest products and information available at www.sealite.com
18
SL07, SLC310 & SLC410
Compact 3-5nm+ Solar Marine Lanterns
The SL07, SLC310 and SLC410 models come with GPS tted as standard, and provide the user with
the ability to install independently operating lanterns that all ash in synchronisation.
No additional power supplies, aerials or control systems are required, and with its microprocessor-
based system, the GPS option is specically designed to provide maximum reliability and performance
over a wide range of environmental conditions.
Operating Principle
Each light operates independently and requires no operator intervention. A minimum of 4 satellites
need to be in view for the built-in GPS receiver to collect time data. At dusk, the light sensor will turn
the light on. If time data is available the light will come on synchronised to every other light with the
same selected ash code.
Synchronisation is achieved using an internal algorithm based on the highly accurate time base and
time data received from the satellites. The satellite data is provided from a number of earth stations
using atomic clocks as the time base. Continuous self-checking ensures that the light will continue to
run in synchronisation.
Light Activation
At power-up the microprocessor checks that the internal GPS module is programmed correctly and is
able to provide valid time base and time data.
Once outside with a clear view of the sky, valid data should become available within 20 minutes.
Daylight Operation
During daylight hours the microprocessor is in idle mode to reduce power consumption. Time data
continues to be updated once per second. The microprocessor will automatically exit the idle mode as
soon as dark conditions are detected.
Dark Operation
When dark conditions are detected the light:
• Checks for valid time data and is turned on after a delay based on the current time and the length
of the selected ash code;
• If valid time data is not detected the light will turn on after approximately 10 seconds. This light will
not be synchronised.
• If the light turns on unsynchronised it will continually check for valid time data. Once valid data is
found the light will automatically synchronise.
Note: Lights will not synchronise if different ash codes are selected.
GPS Power Demand
The GPS synchronisation feature has been designed to function with a very low power demand.
Typically the total 24hr current used by the GPS module is 36mAh. This is approximately equivalent to
8 minutes of solar charging.
Note: To disable GPS synchronisation refer to GPS Synchronisation Control and Status in the IR
Controller Functions section of this manual.
GPS Synchronisation
SL07, SLC310 & SLC410 Models