Use and Care Manual

Reflexion
®
‑UP Foundation
STEP 7
If this delivery involves dual foundations and/or
split mattresses, see instructions for joining two
foundations on page 15.
STEP 8
Carefully ip the Reexion
®
-UP Foundation(s) over to
the topside up position.
NOTE: Make sure to lift the foundation(s) off the
ground before flipping over. DO NOT use legs as
a leverage point to ensure they do not break.
Proper handling
!
Turn bed over without leaning against the
installed legs.
DO NOT
lean the bed against the
installed legs to flip it over.
ATTENTION ! Improper handling
!
STEP 9
Route the control box cable to your preferred side of
the bed.
STEP 10
Installing the Mattress Retainer Bar (C).
STEP 10A
Remove Mattress Retainer Bar (C) from the bottom of
the foundation.
STEP 10B
Remove the Retainer Bar Plates (D) and Retainer Bar
Screws (E) from the accessory bag also attached to the
bottom of the foundation.
STEP 10C
Install Mattress Retainer Bar (C) and install Retainer
Bar Plate (D).
STEP 10D
Hand tighten Retainer Bar Screws (E).
NOTE: Do not overtighten or use power tools
for installation.
STEP 11
Place the mattress(es) on the foundation(s).
WARNING: When placing the foundation(s)
within a bed frame, verify the space between
the headboard cross member and the top of the
mattress is no more than 3 inches.
STEP 12
Ensure the power switch on the surge protector is in
the “on” position and that it is plugged into the wall
outlet. Check the system for functionality with the
mattress in place.
14
TEMPUR SEALY CUSTOMER SERVICE DEPARTMENT: 1–800–499–1965