Use and Care Manual

NOTE:

Programming by the user is only needed on

replacement remotes.

Programming the Remote Control

STEP 1

Insert batteries into the remote control

(2 x AA batteries).

STEP 2

Make sure your Adjustable Base is plugged into

a working grounded outlet or surge protector.

Follow steps 1 through 6 below to use the remote control with 1 power base.

To use the remote control with 2 power bases, repeat the steps for the second power

base using the same remote.

Press any button on the remote control.

When the receiver light ﬂashes, the RF

frequency code learning process is complete.

Hold down the “Learn” button for 3 seconds

to initiate the RF learning mode.

The LED signature light will illuminate.

This means the RF frequency code setting

function has been activated.

STEP 5

STEP 6

STEP 3

STEP 4