Typewriter User Manual

4. HOW TO CHANGE:OORRECTIONTAPE

Takeup Spindle Supply Spindle

Removing Correction Tape

Turn off the machine. Open the Top Cover and remove

the Ribbon Cassette as explairied under "Removing Rib-

bon Cassette".

Remove the left and right spools from the respective spin-

dles. Be sure not to pull on the spindle hub when remov-

ing the right spool.

Tape Guides

3) Grasp both spools and bring back to a position that is

parallel with the Tape Guides. Pull on the Correction Tape

to take up any slack and lift it out of the typewriter.

Card Holder

Print'wheel

Installing Correction Tape

While holding the two spools in your hands, unwind the

Correction Tape and position behind the Tape Guides and

Printwheel as shown. Make sure that the sticky side of

the tape faces the Card Holder.

Takeup Spindle

Supply Spindle

2) Fit the full spool of the Correction Tape onto the Right

(Supply) Spindle. Then fit the left spool (the one with the

knob) onto the Left (Takeup) Spindle.

Turn the left spool counterclockwise until the colored por-

tion of the tape disappears.

Check again to make sure that the Correction Tape has

been fed properly behind the left and right Tape Guides.

4) Replace the Ribbon Cassette and close the Top Cover.