Snow Blower User Manual

ii ii.
E
......................CAUT'iON:NEVE"STORETHEENGINE
WITH FUEL IN THE TANK INDOORS OR
IN AN ENCLOSED, POORLY VENTILATED
AREAWHERE FUEL FUMES MAY REACH
AN OPEN FLAME, SPARK OR PILOT
LIGHT AS ON A FURNACE,. WATER
ttEATER, CLOTHES DRYER, ETC,.
NOTE: Immediately prepare your snow thrower forstor-
age at the end of the season or'if the unit will not be used
for 30 days or more,.
SNOW THROWER
BOWL DRAIN
• Thoroughly clean the snow thrower'.
• Lubricate all lubrication points (see the Mainte-
nance section, pages 15 -16).
• Be sure that all nuts, bolts and screws are securely
fastened. Inspect all visible moving parts for dam-
age, breakage and wear° Replace if necessary.
• Touch up all rusted or chipped paint surfaces; sand
lightlybefore painting,
• Cover the bare metal parts of the blower housing
auger and the impeller with r_Jstpreventative, such
as sprayable lubricant.
NOTE: A yearly checkup o rtuneup by a SEARS Service
Center is a good way to insure that your snow thrower will
provide maximum performance for the next season.,
ENGINE
IMPORTANT: ITIS IMPORTANTTO PREVENTGUM
DEPOSITS FROM FORMING IN
ESSENTIAL FUEL SYSTEM PARTS
SUCH AS THE CARBURETOR, FUEL
FILTER, FUEL HOSE OR TANK
DURING STORAGE.. ALSO,
EXPERIENCE INDICATES THAT
ALCOHOL BLENDED FUELS
(CALLED GASOHOL OR USING
ETHANOL OR METHANOL) CAN
ATTRACT MOISTURE WHICH
LEADS TO SEPARATION AND
FORMATION OF ACIDS DURING
STORAGE. ACIDIC GAS CAN
DAMAGE THE FUEL SYSTEM OFAN
ENGINE WHILE IN STORAGE.
Drain the gasoline from the fuel tank by removing
the fuel line. Drain the fuel and reinstall the fuel lined
FIG. 39
• Start the engine and run at SLOW (idle) speed until
the engine stops from lack of fueL
• Drain the carburetor by pressing upward on the
bowl drain (See Fig_39), located below the carbure-
tor cover_
NOTE: Fuel stabilizer (such as STA-BIL) is an accept-
able alternative in minimizing the formation of fuel gum
deposits dudng storage Add stabilizer to gasoline infuel
tank or storage container, Always follow the mix ratio
found on stabilizer container_ Run engine at least 10
minutes after adding stabilizer to allow the stabilizer' to
reach the carburetor,.Do not drain the gas tank and car-
buretor if using fuel stabilizer_
Remove the spark plug and squirt one (1) ounce of
engine oil into the cylinder. Pult the recoil starter
rope slowly, allowing the piston to coat the internal
engine parts.. Install an old spark plug. This
prevents fouling a new plug with the preservative
used to lubricate the internal parts of the engine_
Close the choke and plug the muffler opening°
OTHER
• If possibJe, store your snow thrower indoors and
cover it to give protection from dust and dirt.
• Ifthe machine mustbe storedoutdoors, block upthe
snow thrower to be sure the entire machine isoff the
ground.
• Cover the snow thrower with a suitable protective
cover that does not retain moisture, Do not use
plastic.,
"'i _ C_'_T'ioN: DRAIN FUEL iNTO i...... ............ .........
Ii
APPROVEDCONTAINEROUTDOOBS,I
, ! AWAY FROM OPEN FLAME. ............. i
IMPORTANT: NEVER COVER SNOW THROWER
WHILE ENGINE AND EXHAUST
AREAS ARE STILL WARM
24