Saw User Manual

Alignment
Align Riving Knife to Blade
The goa! of this adjustment is to position the
riving knife directly in line with the blade.
Riving knife alignment is an important safe-
ty factor, The riving knife rides in the kerf of
the cut work_iece during ripping to keep the
two sides of the workpiece from pinching on
the blade. Blade pinching is a cause of kick-
back,
1. Lock yoke in in-rip position (blade
towards column, motor towards front of
arm).
2. Lower arm until blade just clears table,
3. Unlock rip lock while holding up lower
plastic guard, move yoke back until blade
touches fence. Lock rip lock.
4. Loosen pawls/riving knife knob. Lower
riving knife to the table and tighten knob.
The riving "knife should rest fiat against
fence,
5. If adjustment is needed:
1o)loosen riving knife bracket screw.
Z) slide riving knife so it rests against
fence.
3.) secure riving knife bracket screw,
6, Raise riving knife and tighten pawls/riv-
ing knife knob.
Wrong
Correct
Wrong
Riving Knife
Screw
11