OPERATOR’S MANUAL Portable Power 950 Model No. 28.71987 Read and follow all Safety Rules and Operating Instructions before Every Use of this Product. Save these instructions. Sears Brands Management Corporation, Hoffman Estates, IL 60179 U.S.A.
Table of Contents Section Page IMPORTANT SAFETY INSTRUCTIONS 2 PERSONAL PRECAUTIONS 3 FOLLOW THESE STEPS WHEN connecting to a BATTERY 4 Grounding and AC power cord connections 5 ASSEMBLY INSTRUCTIONS 5 FEATURES 5 Charging the internal battery of the Jump starter 6 OPERATING INSTRUCTIONS 6 MAINTENANCE INSTRUCTIONS 8 Moving and STORAGE INSTRUCTIONS 8 TROUBLESHOOTING 9 SPECIFICATIONS 10 REPLACEMENT PARTS/accessories 10 CONTAINS SEALED NON-SPILLABLE LEAD-ACID BATTERY.
IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL. SAVE THESE INSTRUCTIONS – Charge the jump starter internal battery immediately after purchase, after every use and every 30 days. This manual will show you how to use your jump starter safely and effectively. Please read, understand and follow these instructions and precautions carefully, as this manual contains important safety and operating instructions.
1. IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS This manual contains important safety and operating instructions RISK OF ELECTRIC SHOCK OR FIRE. 1.1 1.2 1.3 Read the entire manual before using this product. Failure to do so could result in serious injury or death. Keep out of reach of children. Use only recommended attachments. Use of an attachment not recommended or sold by the jump starter manufacturer may result in a risk of fire, electric shock or injury to persons or damage to property.
2. PERSONAL PRECAUTIONS RISK OF EXPLOSIVE GASES. A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION. TO REDUCE THE RISK OF A SPARK NEAR THE BATTERY: 2.1 2.2 2.3 2.4 2.5 2.6 2.7 2.8 Working in the vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal battery operation. For this reason, it is of utmost importance that you follow the instructions each time you use the jump starter. NEVER smoke or allow a spark or flame in the vicinity of a battery or engine.
3. FOLLOW THESE STEPS WHEN connecting to a BATTERY A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION. TO REDUCE THE RISK OF A SPARK NEAR THE BATTERY: NEGATIVE GROUNDED SYSTEM 3.1 3.2 3.3 3.4 3.5 3.6 3.7 3.8 Attach the output cables to the battery and chassis as indicated below. Never allow the output clips to touch each other. Position the DC cables to reduce the risk of damage by the hood, door and moving or hot engine parts.
4. Grounding and AC power cord connections RISK OF ELECTRIC SHOCK OR FIRE. 4.1 The jump starter charger is for use on a nominal 120-volt circuit. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances. The plug pins must fit the receptacle (outlet). Do not use with an ungrounded system. 4.
7. 7.1 7.2 Charging the internal battery of the Jump starter Important: charge immediately after purchase, after each use and every 30 days to keep the jump starter INTERNAL BATTERY FULLY CHARGED. To check the internal battery’s charge status, toggle the Light/Display switch to the DISPLAY position. The Digital Display will show the battery’s percent of charge.
Risk of Explosion. If you have connected the clips backwards, an audio alarm will sound. DO NOT turn the On/Off switch to the ON position. This could cause serious damage to the jump starter or the vehicle. Reverse the connections and the audio alarm will stop. 3. Crank the engine. If the engine does not start within 5-8 seconds, stop cranking and wait at least 1 minute before attempting to start the vehicle again. (This permits the battery to cool down.) 4.
8.4 Using the USB Port The USB port provides up to 500mA at 5V DC. 8.5 9. 9.1 9.2 9.3 9.4 9.5 10. 10.1 10.2 10.3 10.4 NOTE: When using the USB port, the clips on the jump starter are live and will produce arcing or sparking if they come in contact with each other. To prevent accidental arcing, always keep the clips on the storage holders when not using it to jump start a vehicle. 1. Ensure that the battery clips are securely clipped on the storage holders. 2.
10.5 IMPORTANT: • CHARGE IMMEDIATELY AFTER PURCHASE • KEEP FULLY CHARGED Charge the jump starter internal battery immediately after purchase, after every use and every 30 days. All batteries are affected by temperature. The ideal storage temperature is at 70 degrees Fahrenheit. The internal battery will gradually self-discharge (lose power) over time, especially in warm environments. Leaving the battery in a discharged state may result in permanent battery damage.
12. SPECIFICATIONS Internal Battery Type DieHard Maintenance-free AGM Lead-acid Nominal Voltage 12V DC Capacity 18 Ah DC Power Outlet (Max. Continuous Load) 15A (both outlets combined) Built-in Light Bulb (Replaceable) Two, 5w/12v Dc (Base type BA9S) Jumper Cables 4-gauge awg, 24 Inches Dimensions (H x W x D) 12 H x 11 x 10.5 Inches Product Weight 18.9 Lbs. 13.
