TM A A A AUTOINCL/NE FITNESSTRAKS,0MPH 1,25HORSEPOWER DCMOTOR Model No. 831.298&50 Serial No. t 0 WNE.R 'S MA NUA L CA UTiON" before using Read all safety precautions and instructions in this manual this equipment. Save this manual for future reference.
IMPORTANT SAFETY PRECAUTIONS - Z WARNING: following 1. Toreduce theriskofburns, fire,electrlo shockorinjurytopersons, readthe Important Position and Information on a level surface, Do not place the treadmill where aerosol Plug the power 2_ precautions the treadmill treadmill. operate safety cord products directly before operating the treadmill.
TABLE OF CONTENTS Before You Begin ............................... Assei'nbly ..................................... _C)peration and Adjustment ........................ Trouble-Shooting and Storage ..................... Conditioning Guidelines .......................... Part List ...................................... 3 4 5 6 g 10 Exploded Drawing .............................. Ordering Replacement Parts ...................... Warranty ......................................
ASSEMBLY set-the included treadmill before in a cleared disposing area and remove the packing of the packing materials. materials, Make sure that all parts are Please read each step carefully before beginning. 1. Raise the Upright Post (13) to a vertical position. Insert the Lock Knob (25), with the Lock Knob Washer (24), into the Upright Post, and turn the Knob clockwise until almost tight. Leave a little play in the Upright Post for the following steps, 2.
OPERATION AND ADJUSTMENT GROUNDING INSTRUCTIONS This product must be grounded, if it should malfunction or break down, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding piug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
TREADMILLOPERATION Read the instructions ° below before starting the treadmill. Step onto the foot rails and hold the side rail with a firm grip. 2, Attach the clip on the safety key to the waistband of your clothing. Insert the safety key into the console, To turn the power on, move the key to the right. The power indicator will light.
b. Insert the safety key into the console and move the key to the right, The power indicator should light. C'," Check the circuit breaker located on the front of the frame near the power cord. The circuit breaker is designed to protect the electrical system. If the circuit breaker has tripped, the switch will protrude as shown. To reset the circuit breaker, allow the treadmill to cool for five minutes, MOVE THE SAFETY KEY TO THE OFF POSITION 2. SYMPTOM: a. Reset Tdpped and push the switch back in. .
7. SYMPTOM:THEWALKINGBELTSLOWSWHENWALKEDON a_ b. Silicone lubricant should be applied to the walking platform before use. Lubricant should be reapptied after every 10 hours of use, and whenever a decrease in performance is noticed. (Uni.Sport silicone spray is recommended,) CAUTION: ALWAYS TURN THE POWER OFF WHEN APPLYING LUBRICANT. (See OPERATION AND ADJUSTMENT in this manual for application instructions.
CONDITIONING The following adequate exercise guidelines GUIDELINES will help you to outline a personal rest and good nutrition are essential program, consult your physician. EXERCISE exercise for successful program. results. Remember Before beginning that this or any INTENSITY To maximize the benefits of exercising, it is important to exercise with the proper intensity. intensity level can be found using the heart rate as a guide.
PART LiST-Model Key No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 t5 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 10 Reorder No. 'I07874 104627 104625 106889 101508 054013 033161 088015 010206 013423 105476 104626 101729 105477 107444 104514 106996 013445 I03855 014041 101757 104925 014087 014156 0 t7088 012108 031231 014157 031103 0 t 3162 031229 013275 014127 104530 052014 103045 101391 013293 012179 NSP 041043 Qty.
I EXPLODED Specifications DRAWING-Model are subject to change without t No. 831.298550 Rev. 4/92 t notice. 12 13 12 25 64 43 23 / 46 45 56 57 \ 47 55 i i \ _" 34 30 39 9 4O 48 53 _49 3O 11
ORDERING REPLACEMENT PARTS Each TREADMILL has its own MODEL requesting or repair parts for your TREADMILL. service NUMBER_ All parts listed herein may be ordered through most SEARS RETAIL STORES. Always mention this MODEL SEARS, ROEBUCK AND COo SERVICE If parts you need are not stocked locally, your order will be electronically PARTS DISTRIBUTION CENTER for expedited handling. WHEN ORDERING 1o The MODEL REPAIR PARTS, ALWAYS GIVE THE FOLLOWING NUMBER NUMBER 4.