Owner`s manual

SPEED: This mode displays the speed of the walkin# belt. Note: Each time the SPEED buttons are
pressed, this mode will be selected automatically for approximately 5 seconds.
CALORIES: This mode displays the total number of Calories you have burned. For accuracy, first
select the WEIGHT SET mode and enter your weight into the console.
PULSE: This mode displays your heart rate. Plug the pulse earclip into the jack on the console, and
attach the earclip to your left ear lobe. Slide the clothes clip onto your collar to prevent excessive
movement of the earclip wire. After a few seconds, your heart rate will be displayed. Note: If your
heart rate is not displayed, rub your ear lobe lightly and reposition the earclip.
SCAN: This mode automatically displays all modes except WEIGHT SET, for approximately 3 seconds
each, in a repeating cycle. Note: The PULSE mode will be displayed only if the pulse earclip isworn.
TURNING OFF THE POWER
Stand on the foot rails of the treadmill. Remove the safety key from the console. WARNING: Always
remove the safety key from the console when you finish exercising.
MAINTENANCE AND TROUBLE-SHOOTING
Be sure that all parts of the treadmill are tightened securely each time you use the treadmill Outside
surfaces of the treadmill can be cleaned using a damp cloth and mild, non-abrasive detergent. Do not
allow liquid to come in contact with the console.
WALKING BELT ADJUSTMENT
10
The walking belt should always be kept centered on the walking platform. If the belt shifts to the right
or left sides of the platform, the belt may be damaged by the roller guard screws. The belt can be
adjusted using the rear roller adjustment bolts and the allen wrench included. CAUTION: ALWAYS
TURN THE POWER OFF BEFORE ADJUSTING THE WALKING BELT.
IF THE WALKING BELT HAS SHIFTED TO THE LEFT:
TURN THE POWER OFF. Turn the left adjustment bolt
clockwise, and the right adjustment bolt counterclockwise,
1/4 of a turn each. Turn the power on. Repeat as
necessary until the belt iscentered.
IF THE WALKING BELT HAS SHIFTED TO THE RIGHT:
TURN THE POWER OFF. Turn the left adjustment bolt
counterclockwise, and the right adjustment bolt clockwise,
1/4 of a turn each. Turn the power on. Repeat as
necessary until the belt is centered.