£SP • 0-10.0 MPH • 1.;_NP DC MOTOR • WIDE TRAKFRAME • SOF[ STRIDEADJU$ TABLE SUSPENSIONDECK • ELECTRONICPOWER INCLINE • MADEIN THE U,S.A. Model No. 831.297051 Serial No. V-erial Number Decal OWNER'S MANUAL CA UTION: Carefully read all safety precautions and instructions in this manual before using this equipment. Save this manual for future reference.
iiii i iii ,11 FULL 90 DAY WARRANTY ON PARTS For 90 days from the date of purchase, when proper assembly and maintenance procedures detailed in the Owner's Manual are followed, SEARS wil!, free of charge, repair or replace and install a replacement ner. This warranty part for any defective part, when this treadmill does not apply when this treadmill SERVICE IS AVAILABLE CENTER/DEPARTMENT is used for commercial SIMPLY BY CONTACTING IN THE UNITED STATES.
ESP • EXTENDED Ak0. I0,0 MPil • I..#HP OC MOTOR •WIDE TRAK FRAME • SOFTSTRIDEAOJUSTABLE 8 TRIOEPROFILE SUSPENSION DECK • ELECTRONICPOWER/NCLINE • MADEIN TIIE U,S.4. TABLE OF CONTENTS Important Safety Precautions ...................... Before "You Begin ............................... Assembly ..................................... Operation and Adjustment ........................ Trouble-Shooting and Storage ..................... Conditioning Guidelines .......................... Part List .............
IMPORTANT SAFETY PRECAUTIONS WARNING: following 1 . To reduce important the risk of burns, safety precautions fire, electric and Information shock or injury to persons, before operating read the the treadmill. Position the treadmill on a level surface, with at least 8 feet of clearance behind the treadmill. Do not place the treadmill near water, outdoors or on a surface that blocks any air opening. Do not operate where aerosol products are used or where oxygen is being administered.
BEFORE YOU BEGIN Thank you for selecting a SEARS _'LIFESTYLER 10.0 ESP treadmill. The LIFESTYLER 10.0 ESP treadmill combines advanced technology with innovative design to let you enjoy an excellent form of cardiovascular exercise in the convenience and privacy of your home. The heart of the treadmill is the innovative OPTIONS* from your exercise.
ASSEMBLY Set the treadmill in a cleared area and remove all packing materials. Included before disposing of the packing Be sure that all parts are materials. Align the lower end of the Right Handrail (20) with the holes in the side of the treadmill Frame (47). Attach the Handrail with two Short Handrail Bolts (35) and Handrail 1, Washers (36). Do not fully tighten the Bolts. Attach the Left Handrail (not shown) in the same manner.
OPERATION AND ADJUSTMENT GROUNDING INSTRUCTIONS This product must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly codes and ordinances.
CONSOLE OPERATION The heart of the treadmill is the innovat ve OPTIONS base console. The OPTIONS base console features a safety key-operated power switch, a large, easy-to-read LED display, convenient pushbutton speed controls and a multiple-mode exercise monitor.
TURNINGTHE POWERON Stepontothe foot rails of the treadmill. WARNING: Do not stand on the walking belt when turning the power on. There is a clip attached by a cord to the safety key. Slide the clip onto your waistband. WARNING: Always wear the clip when operating the treadmill. If you fall, the safety key will be pulled from the base console, instantly turning off the power. Insert the safety key into the base console.
DISTANCE/SET:This modedisplaysthe distanceyou havetraveled. This modealsoallowsdistance goals to be set. Toset a distancegoaT,first selectthe DISTANCE/SET mode. (Makesurethe SCAN modeis not selected.) Pressthe SET buttonsto setthe distanceyouplan to travel. Eachtime oneof the buttonsis pressed,the distancedisplayedwill changeby 0.2 miles. The buttonscan be held down to set a distancegoal quickly. As you exercise,the distancewill be counteddown. Whenthe distance goal is completed,a tone will sound.
TROUBLE-SHOOTING AND STORAGE Most treadmill problems can be solved by following the simple steps below. If further assistance is needed, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). 1. SYMPTOM: THE POWER DOES NOT TURN ON a. Make sure the power cord is plugged into a properly grounded outlet. (See OPERATION AND ADJUSTMENT in this manual.
b. If an extension feet in length. C. cord is needed, use only a 14-gauge general-purpose cord of approximately five If the walking belt is overtightened, treadmill performance may be reduced and the walking belt permanently damaged. TURN THE POWER OFF. Turn beth rear roller adjustment bolts counterclockwise, 1/4 of a turn. Repeat until the tension of the walking belt is correct. When the tension is correct, you should be able to lift each side of the walking belt 3-4 inches off the walking platform.
CONDITIONING GUIDELINES The following guidelines will help you to plan your exercise program. Remember that proper nutrition and adequate rest are essential for successful results. WARNING; Before beginning this or any exercise program, consult your physician. This is especially Important for individuals over the age of 35 or individuals EXERCISE with pre-existing health problems. INTENSITY To maximize the benefits of exercising, it is important to exercise with the proper intensity.
PART LIST--Model KeyReorder No. No. _t4 Qty. No. 831.297051 . Description Rev. 8/92 Key No. Reorder No. Qty.
EXPLODED DRAWINGmModel NO. 831.297051 Re,,e/92 12 11 \ 13 10_76 15 82 71 35 25 126 44 42 15 29 ' 30 : 67 60 © 1992 Sears, Roebuck and Co.
ORDERING REPLACEMENT PARTS Each TREADMILL has its own MODEL NUMBER. Always requesting service or repair parts for your TREADMILL. All parts listed may be ordered SEARS RETAIL STORES. through SEARS, ROEBUCK mention the MODEL AND CO. SERVICE NUMBER CENTERS If parts you need are not stocked locally, your order will be electronically PARTS DISTRIBUTION CENTER for expedited handling. transmitted WHEN ORDERING INFORMATION: 1. The MODEL REPAIR NUMBER of the product 2. The NAME of the product 3.