Stepper Machine User Manual

7
2. Identify the Frame Cover (54), and orient it as
shown. Slide the Frame Cover onto the Frame
(1), and press the posts on the Frame Cover into
the indicated holes in the Frame.
Next, orient the Upright (2) as shown. While a
second person holds the Upright near the Frame
(1), connect the Upper Wire Harness (81) to the
Lower Wire Harness (82).
Tip: Avoid pinching the Wire Harnesses (81,
82). Gently pull the upper end of the Upper Wire
Harness (81) to remove any slack while you
insert the Upright (2) into the Frame (1).
3. Identify the Right Upright Cover (21), which
is marked with an “R” sticker, and orient it as
shown.
While a second person holds the Right Upright
Cover (21) near the Upright (2), tie the indicated
wire tie to the Extension Wire (110). Then, pull
the other end of the wire tie upward out of the
top of the Upright.
Tip: Avoid pinching the Wires (109, 110).
Attach the Left and Right Upright Covers
(20, 21) around the Upright (2) with four M4 x
30mm Screws (74).
Then, insert the Clip (85) onto the underside of
the Left and Right Upright Covers (20, 21).
2
3
2
2
1
Holes
Avoid pinching
the wires
Avoid
pinching
the wires
81
81
74
20
85
110
109
21
74
82
54
Wire Tie