Stepper Machine User Manual

8
4
Avoid pinching
the Heart Rate
Wires (92)
4
5
62
80
92
Wire Tie
80
62
2
4. Identify the Right Handrail (5), which is marked
with an “R” on the underside. Orient the Right
Handrail as shown.
While a second person holds the Right Handrail
(5) near the Upright (2), tie the indicated wire tie
to the Right Heart Rate Wire (92). Then, pull the
other end of the wire tie upward out of the top of
the Upright.
See the inset drawing. Insert the lower end of
the Right Handrail (5) into the opening between
the Right Outer Shield (17) and the Right Inner
Shield (19).
Tip: Avoid pinching the Heart Rate Wire (92).
Attach the Right Handrail (5) to the Upright (2)
with four M8 x 13mm Screws (62) and four M8
Split Washers (80). Do not tighten the Screws
yet.
Attach the Left Handrail (4) in the same way.
5
5. Attach the Right Handrail (5) to the Frame (1)
with three M10 x 20mm Screws (61). Do not
tighten the Screws yet.
Attach the Left Handrail (4) in the same way.
Next, attach the Upright (2) with four M10 x
20mm Screws (61) and four M10 Split Washers
(79). Do not tighten the Screws yet.
4
5
61
61
1
5
19
17
79
2
79
61
61