Owner`s manual

Problem Possible Cause Solution
Machine Power cord not plugged in. Plug into a grounded 3 prong outlet.
Stops
No power at plug. Check electrical source or call
eIectrician.
Fuse blown or circuit Replace fuse or reset circuit breaker.
breaker open. If problem continues, calI eIectrician.
Using an extension cord. Do not use extension cords.
Timer is not lined up. Turn timer to the right slightly
and pull to start.
Timer knob not pulled out. Set and pull out knob.
Machine is overloaded. Wash smaller Ioads.
Agitator Not The top of the agitator moves This is normal.
Working only in one direction.
The top of the agitator is loose. This is normal.
Water Level The top of the agitator is much This is normal.
Too Low/Not higher than the highest water
Completely level. This creates a perception
Filling of the washer not being fuIl.
Tub is Tub pulled forward when Ensure tub is centered before
Crooked unloading, starting washer.
Tub moves. This is normal,
Unit not level, Ensure front feet are installed and
nuts are tightened. Levelwasher.
Reset rear legs (see "Installation
Instructions,"Section G).
Lint on Load Improper sorting. Sort lint givers from lint takers
and by color.
OverIoading. Lint can be trapped in load if
overIoaded. Wash smaller loads.
Paper or tissue in pockets. CIean out pockets before washing.
Not enough detergent. Use enough detergent to
hold lint in water.
Detergent not dissolving. Use wash water warmer than
Water temperature lowerthan 70°F (21°C).
70°F (21°C).
32