User`s manual

© 2012 Teleflex Marine, Inc. Optimus 360 Users Manual, Rev. A
43
8.3 System Inspection (continued)
4. Check for binding, loose, worn or leaking steering or shift/
throttle control components.
Check all shift and throttle cables and harnesses for signs of
wear, damage or chafing. Check that all linkages and cables
move freely and are not binding or corroded.
5. Verify proper shift and throttle response for all control handles.
Check that all shift and throttle levers operate freely and cause
the engines to shift accordingly. Put the engines in neutral
idle mode and confirm that the throttle responds correctly and
returns to idle.
6. Verify that no faults or warnings are shown on the CANtrak
display or the Shift and Throttle Control Head.
If warnings are found on the CANtrak display, follow the
instructions on the CANtrak screen or refer to Section 10 before
proceeding.
Read the System Inspection steps on the CANtrak display and
acknowledge them by pressing the right hand most button under
OK.
It is recommended the full system inspection be reviewed on a
regular basis to retain familiarity.
After becoming familiar with the system inspection process, the
operator can use the OK button to acknowledge that the system
inspection process was understood and completed and can then go
directly to the steering mode screen.
Do not operate the boat if any component is not in proper working
condition.