User`s manual

© 2012 Teleflex Marine, Inc. Optimus 360 Users Manual, Rev. A
59
10.2.5 CANtrak Loss of Display (continued)
3. In the event of a loss of steering or shift and throttle response
and CANtrak display, and you are unable to obtain assistance
and are in an emergency situation, engage Limp Home Modes 1,
2 or 3:
Limp Home Mode 1
If the steering system can no longer provide steering to ANY of
the engines, proceed by using Limp Home Mode 1, as follows:
1. Always wear PFD devices.
2.
Put engine(s) in Neutral.
3. Open Steering Service Valves.
4. Manually center all engines.
5. Close Steering Service Valves
6. Return to port using throttles to steer.
Limp Home Mode 2
If the steering system can no longer provide steering to ONE of
the engines, proceed by using Limp Home Mode 2, as follows:
1. Always wear PFD devices.
2. Put engine(s) in Neutral.
3.
Open Steering Service Valves.
4. Turn affected engine fully away from other.
5. Close Steering Service Valves
6. Fully tilt affected engine.
7. Return to port.
In the event of loss of shift and throttle response to both engines,
proceed by using Limp Home Mode 3, as follows:
Limp Home Mode 3
1. Locate and identify shift and throttle actuators. Read
labels.
2.
Set all lever A(s) into manual override position.
3. Slowly turn (shift) lever B to engage gear. Then slowly turn
(throttle) lever B to raise RPM.
4.
Key off ignition to slow & stop.
Limp home mode is an override system. It may severely limit your
boat control. It should ONLY be used in an emergency if you are
unable to call for assistance. Proceed with extreme caution.
Always wear PFDs and lanyard. Refer to the notice in Section 10.0.