User manual

SeaSTAR 3100LRS USER MANUAL
Issue 1.0 08/02
14
Cable Installation
• Cables must be correctly installed for optimum system operation.
Therefore, the following should be noted:
• Do not route an L-Band receiver remote antenna cable with the cabling
of any other radio system. This may cause interference between both
systems.
• If at all possible, do not run L-Band receiver antenna cables parallel to
other radio system cabling closer than 30 centimetres.
• If cables must cross, ensure that they cross at an angle of
90°. This minimises the possibility of interference.
• As far as is practicable, ensure that cables and I/O connectors are
unique and fit only in their allocated location.
• Avoid routing cables along-side power generator cabling and other high
electrical noise sources. This can cause interference.
• Do not kink or force cables into sharp bends that may damage the
cables and cause system failure.
• After installation, ensure that excess cable in looped and clamped or
tied safely away from any control cables, fuel lines, hydraulic lines or
moving parts.
When stowing over length cables, form loops not less than
150mm minimum cable bend radius.
• Cable routing must avoid high temperature exposure
(e.g. exhaust manifold).
FSPAS Ref.: B31005102PMBRA0